Offline |
Future Club member hopefully! |
|
Joined: Sun Sep 20, 2009 4:27 pm Posts: 362
Location: Perth, Australia
|
I have a question about the steering clamp bolt. Long story short; after doing some work on the clamp and then driving the car I had, ahem, a large washer fall on my foot. It’s centre dia is the same as the steering clamp bolt and while I would normally have expected to remove the bolt assy easily and carefully I did have an unusually difficult time punching out the bolt retaining pin.
I think the washer slid off and got caught on something before falling to the floor later. There’s no washer shown in either of the manuals I have though, but it seems highly unlikely the washer came from anywhere else.
So the questions is : does the washer go on the bolt head side or the steering column adjuster handle side?
I’m assuming the former meaning the retaining pin will need to be punched out again…….
|
|