The Triumph Dolomite Club - Discussion Forum http://forum.triumphdolomite.co.uk/ |
|
Cam Cover Gasket http://forum.triumphdolomite.co.uk/viewtopic.php?t=34036 |
Page 1 of 1 |
Author: | AlanH [ Mon Jun 04, 2018 9:39 pm ] |
Post subject: | Cam Cover Gasket |
I am replacing the cam cover gasket on my 1850 but it seems too wide to fit between the outside lip and the inside one (where the metal bends). I have done this before but can't remember having a problem. I think it was from Rimmers, has anybody else had this, if so does anybody know of another supplier? |
Author: | cleverusername [ Mon Jun 04, 2018 11:04 pm ] |
Post subject: | Re: Cam Cover Gasket |
Quote:
I am replacing the cam cover gasket on my 1850 but it seems too wide to fit between the outside lip and the inside one (where the metal bends). I have done this before but can't remember having a problem.
Ah the brothers, best not comment on them.I think it was from Rimmers, has anybody else had this, if so does anybody know of another supplier? You want GEG447, Robsport https://robsport.co.uk/index.php/online ... kets-sealshas it and so does http://www.tdfitchett.co.uk/store/dolom ... 50-geg447/ tdfitchett. Can't comment on the quality, don't have an 1850, but Robsport are my go to supplier. Never had a duff part and they have reasonable postage. It looks cork like the 1500 one, I had to use some sealant to stick it inside the cover to make it fit. Don't know if that would work for the 1850. |
Author: | Toledo Man [ Tue Jun 05, 2018 6:25 am ] |
Post subject: | Re: Cam Cover Gasket |
TD Fitchett is another supplier I'd recommend. S&S Preparations are also worth a try. |
Author: | xvivalve [ Tue Jun 05, 2018 8:21 am ] |
Post subject: | Re: Cam Cover Gasket |
The names listed are retailers, there are limited ‘suppliers’ for these items and most source stock from the same places...or from each other. |
Author: | AlanH [ Tue Jun 05, 2018 11:46 am ] |
Post subject: | Re: Cam Cover Gasket |
I think that I will try trimming the one that I have. |
Author: | AlanH [ Fri Jun 08, 2018 10:09 pm ] | ||||
Post subject: | Re: Cam Cover Gasket | ||||
I needed some bits so I thought that I would get them from Robsport and include a cam cover gasket. Sure enough, as you can see from the photo below, it is thinner. However, as the other photos show, it is too long. Luckily I have found an old gasket in reasonable condition that seems to fit.
|
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |