The Triumph Dolomite Club - Discussion Forum http://forum.triumphdolomite.co.uk/ |
|
Rear Hub oil seal http://forum.triumphdolomite.co.uk/viewtopic.php?t=34175 |
Page 1 of 1 |
Author: | AlanH [ Thu Jul 12, 2018 9:34 pm ] |
Post subject: | Rear Hub oil seal |
I am putting my half-shaft back together I assume that the outer oil seal (GHS184) should fit snug around the hub (which it doesn't). Can anybody confirm this. |
Author: | AlanH [ Sat Jul 14, 2018 5:44 pm ] |
Post subject: | Re: Rear Hub oil seal - what size is your hub |
I have measured the hub diameter at 33.5 (ish). The seal supplied by Rimmers (GHS184) is 36 47 7 This is the same as the TR7 but Obviously is wrong. Has anybody sourced these from any where else? I have found a 32 - 47 - 7 and a 1 5/16 - 1 7/8 - 5/16 imperial. Surely someone has fitted these before - where did you get yours from ? |
Author: | RJF_70 [ Sat Jul 14, 2018 6:05 pm ] |
Post subject: | Re: Rear Hub oil seal |
When I did mine on my 1850 I bought the kit from Canley Classics, although I was only changing the hub seal. I still have the box containing Bearing, pin and another seal, it's a Trupart Wheel Bearing Kit TBK012 or as on box top GHK1007. The seal I have remaining has the numbers SC24 47 10 Rich |
Author: | AlanH [ Thu Jul 19, 2018 5:02 pm ] |
Post subject: | Re: Rear Hub oil seal |
Managed to get a seal that seems to fit. 33 47 8 . May be worth making a note of. |
Author: | Galileo [ Thu Jul 19, 2018 6:56 pm ] |
Post subject: | Re: Rear Hub oil seal |
You can use the gearbox nose seal on a Sprint axle for a nice tight fit though assume the 1300/1500/1850 shaft will be smaller diameter. I buy my seals from: Jonathan Welch Oil Seal UK sales@oilsealuk.co.uk www.oilsealuk.co.uk |
Author: | AlanH [ Thu Jul 19, 2018 10:09 pm ] |
Post subject: | Re: Rear Hub oil seal |
Anybody got a recommendation for lubrication. |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |