The Triumph Dolomite Club - Discussion Forum
http://forum.triumphdolomite.co.uk/

Rear Hub oil seal
http://forum.triumphdolomite.co.uk/viewtopic.php?t=34175
Page 1 of 1

Author:  AlanH [ Thu Jul 12, 2018 9:34 pm ]
Post subject:  Rear Hub oil seal

I am putting my half-shaft back together

I assume that the outer oil seal (GHS184) should fit snug around the hub (which it doesn't).

Can anybody confirm this.

Author:  AlanH [ Sat Jul 14, 2018 5:44 pm ]
Post subject:  Re: Rear Hub oil seal - what size is your hub

I have measured the hub diameter at 33.5 (ish).

The seal supplied by Rimmers (GHS184) is 36 47 7

This is the same as the TR7 but Obviously is wrong.

Has anybody sourced these from any where else?

I have found a 32 - 47 - 7 and a 1 5/16 - 1 7/8 - 5/16 imperial.

Surely someone has fitted these before - where did you get yours from ?

Author:  RJF_70 [ Sat Jul 14, 2018 6:05 pm ]
Post subject:  Re: Rear Hub oil seal

When I did mine on my 1850 I bought the kit from Canley Classics, although I was only changing the hub seal. I still have the box containing Bearing, pin and another seal, it's a Trupart Wheel Bearing Kit TBK012 or as on box top GHK1007. The seal I have remaining has the numbers SC24 47 10
Rich

Author:  AlanH [ Thu Jul 19, 2018 5:02 pm ]
Post subject:  Re: Rear Hub oil seal

Managed to get a seal that seems to fit.

33 47 8 . May be worth making a note of.

Author:  Galileo [ Thu Jul 19, 2018 6:56 pm ]
Post subject:  Re: Rear Hub oil seal

You can use the gearbox nose seal on a Sprint axle for a nice tight fit though assume the 1300/1500/1850 shaft will be smaller diameter.

I buy my seals from:

Jonathan Welch
Oil Seal UK
sales@oilsealuk.co.uk
www.oilsealuk.co.uk

Author:  AlanH [ Thu Jul 19, 2018 10:09 pm ]
Post subject:  Re: Rear Hub oil seal

Anybody got a recommendation for lubrication.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/