I am at the stage of putting a floor in the dodgem mower. The span of the floor is about 830mm. The length is about 800mm. It will be carried on a frame of 25mm square box section, the spacing of which is as yet not finalised. I would appreciate any advice on the thickness of sheet steel I should use. Also with respect to the spacing of the box section. I had 1mm in mind for the sheet steel. Many thanks.
Regards,
Richard
Sheet Steel for Floor Pan
-
Carledo
- TDC Shropshire Area Organiser
- Posts: 7166
- Joined: Sun Aug 21, 2011 5:12 pm
- Location: Highley, Shropshire
Re: Sheet Steel for Floor Pan
1mm sheet should be fine. I'd give a box perimeter at least one central brace bar or maybe a cross and attach the floor to it with rivets or similar, not so much for strength as to stop it bowing and booming if unsupported.
Steve
Steve
'73 2 door Toledo with Vauxhall Carlton 2.0 8v engine (The Carledo)
'78 Sprint Auto with Vauxhall Omega 2.2 16v engine (The Dolomega)
'72 Triumph 1500FWD in Slate Grey, Now with RWD and Carledo powertrain!
Maverick Triumph, Servicing, Repairs, Electrical, Recomissioning, MOT prep, Trackerjack brake fitting service.
Apprentice served Triumph Specialist for 50 years. PM for more info or quotes.
'78 Sprint Auto with Vauxhall Omega 2.2 16v engine (The Dolomega)
'72 Triumph 1500FWD in Slate Grey, Now with RWD and Carledo powertrain!
Maverick Triumph, Servicing, Repairs, Electrical, Recomissioning, MOT prep, Trackerjack brake fitting service.
Apprentice served Triumph Specialist for 50 years. PM for more info or quotes.