The Triumph Dolomite Club - Discussion Forum

Holiday97 wrote: ↑Fri May 09, 2025 3:38 pm When I replaced my rear studs I removed the hub and worked on my bench, which worked out much better.

Thanks I thought about that but read that it can be a right pain removing the hub without the correct puller did you replace the backplate

bazyerma wrote: ↑Fri May 09, 2025 8:05 am Hi Chumley

When I fitted my MG studs, I did away with the back plate and put Loctite on the splines and I have had no issues.

Regards

Barry

Thanks for the reply Barry that’s good to know

Hi just thought I’d post this might be of some use to someone in the future. I needed to change rear studs so thought I would try without removing hubs because either way the cover needs to come off the back of hub. I tapped carefully has I could around hub and tapped back one section fully to see ...

Thanks very much very helpful

Hi everyone
First post on the forum hope you can help me, I have a dolomite sprint and having trouble selecting reverse. Firstly a stupid question you don't have to lift or push down to select reverse do you has I'm struggling to engage it . It goes in but it needs a good shove and when I take it ...