The Triumph Dolomite Club - Discussion Forum http://forum.triumphdolomite.co.uk/ |
|
Sheet Steel for Floor Pan http://forum.triumphdolomite.co.uk/viewtopic.php?t=35314 |
Page 1 of 1 |
Author: | YoungManGoneWest [ Wed Sep 25, 2019 10:51 pm ] |
Post subject: | Sheet Steel for Floor Pan |
I am at the stage of putting a floor in the dodgem mower. The span of the floor is about 830mm. The length is about 800mm. It will be carried on a frame of 25mm square box section, the spacing of which is as yet not finalised. I would appreciate any advice on the thickness of sheet steel I should use. Also with respect to the spacing of the box section. I had 1mm in mind for the sheet steel. Many thanks. Regards, Richard |
Author: | Carledo [ Wed Sep 25, 2019 11:00 pm ] |
Post subject: | Re: Sheet Steel for Floor Pan |
1mm sheet should be fine. I'd give a box perimeter at least one central brace bar or maybe a cross and attach the floor to it with rivets or similar, not so much for strength as to stop it bowing and booming if unsupported. Steve |
Author: | YoungManGoneWest [ Wed Sep 25, 2019 11:04 pm ] |
Post subject: | Re: Sheet Steel for Floor Pan |
Many thanks Steve. Regards, Richard |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |