The Triumph Dolomite Club - Discussion Forum http://forum.triumphdolomite.co.uk/ |
|
Head gasket thickness http://forum.triumphdolomite.co.uk/viewtopic.php?t=35461 |
Page 1 of 1 |
Author: | OttoB [ Sat Dec 14, 2019 8:29 am ] |
Post subject: | Head gasket thickness |
Hello New engine project for Gr1 is at planning stage. Homologation gives compression ratio 10,7:1, and also combustion chamber volume is fixed, so only variable is squish distance. New HG uncompressed thickness is 2,0 - 2,1 mm. Is there another options for gasket? Or what might be compressed thickness of this head gasket? |
Author: | soe8m [ Sun Dec 22, 2019 1:41 pm ] |
Post subject: | Re: Head gasket thickness |
The gasket is about 1,2mm compressed. I alway's skim the engineblock to have the pistons sticking out to raise compression ratio. Jeroen |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |