The Triumph Dolomite Club - Discussion Forum
http://forum.triumphdolomite.co.uk/

Head gasket thickness
http://forum.triumphdolomite.co.uk/viewtopic.php?f=3&t=35461
Page 1 of 1

Author:  OttoB [Sat Dec 14, 2019 8:29 am ]
Post subject:  Head gasket thickness

Hello

New engine project for Gr1 is at planning stage.

Homologation gives compression ratio 10,7:1, and also combustion chamber volume is fixed, so only variable is squish distance.

New HG uncompressed thickness is 2,0 - 2,1 mm. Is there another options for gasket? Or what might be compressed thickness of this head gasket?

Author:  soe8m [Sun Dec 22, 2019 1:41 pm ]
Post subject:  Re: Head gasket thickness

The gasket is about 1,2mm compressed. I alway's skim the engineblock to have the pistons sticking out to raise compression ratio.

Jeroen

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/