The Triumph Dolomite Club - Discussion Forum

just been removing above carbs from manifold and it seemed they weren't done up to the hilt,they have very wide spring washers .
i am i right in thinking this is how they should be and this is some kind of anti vibration set up

rich

yes
Should all have about the same gap between washers

HAVING THE MANIFOLD TOOK OUT TO THE SIZE OF THE GASKET AND MATCHED TO THE HEAD ,
ANY TIPS ON WHAT TO DO /NOT TO DO DAZ.

RICH

ANY MOVEMENT ON THE BIG VALVE HEAD YOU WERE LOOKING IN TOO

Get the manifold dowled to the head
Cut the thermostat off and have it remote
Have the inlet manifold gasket made of a non heat conducting material 5mm thick
have the cyl head manifold mating face machined off by 5mm for gasket
God how many more secrets do i give away
Big valve head.
I have had too many cosworth heads to do i have just about finnished one and thats took me 2 weeks