The Triumph Dolomite Club - Discussion Forum http://forum.triumphdolomite.co.uk/ |
|
1850 subframe rear mounting hole repair http://forum.triumphdolomite.co.uk/viewtopic.php?t=34490 |
Page 1 of 1 |
Author: | xvivalve [ Sun Nov 11, 2018 10:02 pm ] |
Post subject: | Re: 1850 subframe rear mounting hole repair |
It is a common repair! Often used are the same washers that sit beneath the subframe mounting bolt heads in the engine bay. (obviously you don't use your actual existing washers, they are still needed; you need to source additional ones!) |
Author: | GaryR22 [ Sun Nov 11, 2018 10:08 pm ] |
Post subject: | Re: 1850 subframe rear mounting hole repair |
Many thanks for the prompt reply. Those are the very washers I’ve sourced to do the job. Any idea what diameter I should widen the holes to? |
Author: | TrustNo1 [ Sun Nov 11, 2018 11:32 pm ] |
Post subject: | Re: 1850 subframe rear mounting hole repair |
last time I done that I used thick washers welded on. |
Author: | xvivalve [ Mon Nov 12, 2018 10:03 am ] |
Post subject: | Re: 1850 subframe rear mounting hole repair |
When I did this repair, I didn't widen the hole, I just made sure it was positioned centrally |
Author: | GaryR22 [ Mon Nov 12, 2018 8:15 pm ] |
Post subject: | Re: 1850 subframe rear mounting hole repair |
Many thanks to you all - much appreciated! |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |