The Triumph Dolomite Club - Discussion Forum
http://forum.triumphdolomite.co.uk/

Standard Sprint cam ?
http://forum.triumphdolomite.co.uk/viewtopic.php?t=34679
Page 1 of 1

Author:  MIG Wielder [ Fri Jan 25, 2019 5:25 pm ]
Post subject:  Standard Sprint cam ?

Is a Sprint camshaft with the following markings a standard Triumph one please ?

88 3121 32 MC86228 D

These are on the body casting there are no numbers on the end plates.

Thanks ,
Tony.

Author:  xvivalve [ Sat Jan 26, 2019 8:50 am ]
Post subject:  Re: Standard Sprint cam ?

Probably. Can you show a picture of a lobe? Or if coming to Jon’s today, bring it along?

Author:  MIG Wielder [ Sun Jan 27, 2019 10:21 pm ]
Post subject:  Re: Standard Sprint cam ?

Hi Alun, Thanks very much for all your comments and advice. I did the measurements as you suggest and I have a difference of 0.343 to 0.350 over all the lobes, being the lift of the cam. So pretty well standard then. I did look for Jeroens comments as well from previous posts and this seems to agree.
Thanks All.
Onwards and upwards as they say. :D
Tony.

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/