The Triumph Dolomite Club - Discussion Forum http://forum.triumphdolomite.co.uk/ |
|
Bulk head insulation http://forum.triumphdolomite.co.uk/viewtopic.php?t=35196 |
Page 1 of 1 |
Author: | new to this [ Sun Aug 11, 2019 1:36 pm ] |
Post subject: | Bulk head insulation |
Can you buy new engine bulk head insulation,mines rotted away by the servo,and can you fit one of the engine is still in place Thanks Dave |
Author: | sprintchris [ Sun Aug 11, 2019 2:49 pm ] |
Post subject: | Re: Bulk head insulation |
Check this out! Triumph Dolomite SPRINT** BULKHEAD INSULATION PAD - In Engine Bay NEW **RHD cars https://rover.ebay.com/rover/0/0/0?mpre ... 3308367961 |
Author: | Mad Mart [ Sun Aug 11, 2019 5:29 pm ] |
Post subject: | Re: Bulk head insulation |
Try Aldridge. That's where I got the one for XJX. https://forum.triumphdolomite.co.uk/vie ... &start=180 scroll down. |
Author: | 80Sprint [ Wed Aug 14, 2019 8:46 pm ] |
Post subject: | Re: Bulk head insulation |
I have half an original one but unfortunately I think what is buried in the garage is the fan side. |
Author: | new to this [ Thu Aug 15, 2019 10:16 am ] |
Post subject: | Re: Bulk head insulation |
Quote:
I have half an original one but unfortunately I think what is buried in the garage is the fan side.
Thanks but it's the driver side i needDave |
Author: | new to this [ Thu Aug 15, 2019 10:20 am ] |
Post subject: | Re: Bulk head insulation |
Thank for the replys,didn't know you could buy them ,there not cheap Is it possible to fit with engine in place |
Author: | oily66 [ Thu Aug 15, 2019 11:07 pm ] |
Post subject: | Re: Bulk head insulation |
I think you would struggle, certainly with the contact adhesive I used. You haven’t got long and only one go at it. |
Author: | xvivalve [ Fri Aug 16, 2019 10:35 am ] |
Post subject: | Re: Bulk head insulation |
I have an early moulded original, though it's taken from an 1850 auto. It's complete, but some of the thin bits between holes are fragile... |
Author: | new to this [ Sun Aug 18, 2019 8:58 pm ] |
Post subject: | Re: Bulk head insulation |
Quote:
I have an early moulded original, though it's taken from an 1850 auto. It's complete, but some of the thin bits between holes are fragile...
AlunnThanks that would be good Thanks Dave |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |