That is a good job Darrell.
I have had a go at this using correx board, which has turned out okay but
what I have struggled with is recovering the rail and have yet to find a solution.
Delft blue is a smart colour.
Is that a 13” steering wheel?
I am going to try one but am fitting a 3.25 turns rack and 185 section tyres.....
The rail wasn’t easy, I cut the Vinyl out, it’s a strip about 4 1/2” wide, I then put masking tape on the area that contacts the sponge, and apply the spray glue to the lower edge and lower part of vinyl, remove half of the masking tape from that side,
Fit the lower edge, I found it best to wrap round the sponge and attach it to the lower edge like that,
Once it has grabbed apply spay glue to the top edge and vinyl, remove remaining masking tape and attach to top edge, apply some heat to the bends,
Hope this helps,
This is the First time I have done it so I am not an expert,
And yes it is a 13” Mountey Steering Wheel which i modified in order to fit the Dolomite Pad.
I bought it back in the early 80s, it used to be on a Hillman Imp, then A Vauxhall Magnum, Those cars long since gone, but I kept the wheel,