The Triumph Dolomite Club - Discussion Forum
http://forum.triumphdolomite.co.uk/

[1300 TC FWD] Weird front rubber configuration
http://forum.triumphdolomite.co.uk/viewtopic.php?t=36753
Page 2 of 2

Author:  trubac [ Mon Jun 21, 2021 11:41 am ]
Post subject:  Re: [1300 TC FWD] Weird front rubber configuration

Quote:

Export arrangement from Belgium? I have a French imported 1300 what was build in Belgium and a Dutch 1300tc made in Belgium. These don't differ from eachother except early and late, carbs etc. but these dont differ from the UK spec other than mine have the steering wheel fitted on the correct side. Also enginemounts the same as the UK spec and the same through the whole range.

Jeroen
It is a mystery then as I'm pretty sure that mine hasn't been modified as the parts seems really genuine (exactly as the Reparation Operation Manual, page 4-102). But for sure this arrangement is weird ...

Author:  trubac [ Mon Jun 28, 2021 9:20 am ]
Post subject:  Re: [1300 TC FWD] Weird front rubber configuration

Quote:
sorry it the camera angle, its 50 from bottom of plate to top of bolt and 35 to top of rubber.
Finally measured mine (T2000) and in situ it is approx 35mm thick ... compressed. I will ask a T2000 guy to measure it unloaded.

Page 2 of 2 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/