Last bit of metal to go in on the windscreen/dash area. Thank god.
You're upside down, on a cold metal sloping surface with welding sparks falling down on you. Also makes the top of the welds look s##t as gravity pulls the weld pool downwards. Still got to grind it down too which is even more unpleasant as you have red hot iron filings being flung out at you. You try to be on the bottom side of the grinder as less sparks but they're still falling downwards thanks to gravity.
What you see above is two hours of work...
Make a template out of card/thick paper
Cut template to shape
Transfer to metal
Cut metal with cutting disc
Shape metal with flap disc
Clean up metal
Offer up metal to body
Reshape metal to fit some more because you cut out on the wrong side of the line
Repeat the last two a couple of times
Attempt to align the metal in place while fixing into place with magnets
Swear when the magnets and the carefully aligned metal falls onto your face when you let go
Put magnets back on but with a wedge to try stopping them falling off again
Tack into place while using a screwdriver/hammer to keep pressure on area lined up
Weld between tacks
Use air to put out the nearby underseal that's now on fire
Move out of the area because the underseal fumes are wrank and can't be good for your health
Put respirator on
Weld some more
Use air line to try removing condensation from inside your helmet thanks to the respirator
Start welding again but through fog
Swear and do a dance because a hot molten ball of weld has just gone through your Sketchers/inappropriate footwear
Do the above for an hour
Finally sigh at the awful looking welds in the knowledge they'll look respectable once you've run the flap disc over them and also appreciate you don't do this for a day job