The Triumph Dolomite Club - Discussion Forum

The Number One Club for owners of Triumph's range of small saloons from the 1960s and 1970s.
It is currently Wed May 12, 2021 5:52 am

All times are UTC




Post new topic Reply to topic  [1 post ] 
Author Message
PostPosted:Thu Mar 18, 2021 5:44 pm 
Offline
TDC Member
User avatar

Joined:Mon Jun 21, 2010 11:06 pm
Posts:67
Location:Limerick, Ireland
Hello,
Was tidying my PC's picture and music folders and came across this one from the inside of my last garage before we moved house 6 years ago. I installed it myself: the boiler is a kerosene-fired domestic Firebird 90, with room sealed burner, jetted for 22 KW output. The sealed hydronic pipework feeds a MARK Tanner MDA water-to-air heat exchanger with built in fan, rated at 20KW. This unit is actually built in Ireland at the MARK Eire BV facility near Macroom, Co. Cork, actually not too far from Firebird's boiler factory in Ballymakeera, Cork. The boiler also heats a single radiator in a partitioned off office. Controls wise, a dual zone timer fires the boiler and circulation pump only when it is just the office that requires heat, the other zoned output powers the Tanner's air circulation fan via a room stat in the garage and a pipe stat (to prevent the fan operating until the delivery pipework warms up - so as not to be blasted with cold air. Found the system to be very efficient and fast, even when the up'n'over door was opened and all the heat was lost, once the door was shut it warmed up in minutes. Very economical also. I found that an ambient temp of 10 - 15C was plenty when working in the garage, no need to tbe heating it to the same level as a domestic setting. Even an ambient setting of 5C was enough to prevent condensation. The plumbing was all in copper, with a pressure reduction manifold and expansion vessel, charged via a male BSP fitting with a 'Hozelock' type nipple from the garden tap via a temporary hose. 2 gallons of automotive antifreeze was filled via a funnel first - just in case the boiler or the frost stat failed. Also two pics from a similar installation I did for a friend's joinery workshop, he is a software engineer and he built a clever control system for the setup, including remote monitoring, using an Arduino microcontroller.


Attachments:
File comment:My old garage
garage2.JPG
garage2.JPG [143.49KiB |Viewed 128 times ]
File comment:Joinery workshop boiler
Picture2.jpg
Picture2.jpg [86.07KiB |Viewed 128 times ]
File comment:Joinery workshop warm air unit
Picture1.jpg
Picture1.jpg [152.67KiB |Viewed 128 times ]

_________________
1977 Dolomite 1300 Brooklands Green, 10 trouble free years
2007 Toyota Auris Terra (boring but reliable daily driver)
Top
   
Display posts from previous: Sort by 
Post new topic Reply to topic  [1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited