Page 1 of 1
Ten minute engine buildup.....
Posted: Sun Oct 22, 2006 5:11 pm
by Lewis
http://video.google.nl/videoplay?docid= ... 7730806107
Quite a neat little video I thought
Shows you pretty much everything, anyway. Seems to have a particuarly easy time with the piston rings
Will get around to doing something like this come Christmas!
Posted: Mon Oct 23, 2006 9:09 am
by Sprint36
If only Dolomite engines had their main bearings supported like that!
I didn't see him put any thrust bearings in!
David
Posted: Mon Oct 23, 2006 9:17 am
by Dollyboy
i reckon Alg1k and the jedi master have the power to work at that rate...
Posted: Mon Oct 23, 2006 10:42 am
by ALGIK
Thrust bearings are allready on the centre bearing like the rover V8
GOOD vid
But when you torque the rod bolts up you should use a feeler gauge between the crank and rod to stop the rod twisting and bruising the bearing if any of you should be attempting a 10 min build
Posted: Mon Oct 23, 2006 12:40 pm
by Sprint36
Yes, I can see that now I've watched again.
Good tip on the big ends cheers.
David
CAM TIMING
Posted: Mon Oct 23, 2006 8:39 pm
by rich
WHEN the lad sticks his tongue out is the the lad in the back ground timing in his cam
Posted: Mon Oct 23, 2006 8:53 pm
by Dollyboy
i liked the 'check me out' face when the blower went on, and wondered what sort of face mr faulkener made when his went on...
Posted: Mon Oct 23, 2006 11:47 pm
by ALGIK
[quote="Dollyboy"]i liked the 'check me out' face when the blower went on, and wondered what sort of face mr faulkner made when his went on...
:dingdong
My face had a happy smile when the bonnet actually shut