Page 1 of 1
Can anyone identify this bracket please .....
Posted: Wed Jun 01, 2016 5:11 pm
by MIG Wielder
.... which I got in a box of useful Dolomite bits. It looks similar to the parcel shelf side bracket but there are no holes for the shelf fixings and this is rounded. The masking tape retains a short plastic clip-on shield that seems to go with it.
Thanks,
Tony.
- dolly bracket.jpg (90.14 KiB) Viewed 957 times
Re: Can anyone identify this bracket please .....
Posted: Wed Jun 01, 2016 5:15 pm
by shaunroche
Hmmm..think it sits under the parcel shelf horizontally, somewhere near the transmission tunnel?
Re: Can anyone identify this bracket please .....
Posted: Wed Jun 01, 2016 5:16 pm
by xvivalve
Nope!
The only place I can think of where it might fit is where the front parcel shelf inflects above each side of the transmission tunnel, but the reinforcers under the shelf that I've seen don't look like that...
Re: Can anyone identify this bracket please .....
Posted: Wed Jun 01, 2016 5:39 pm
by Ron1966
I think it is the bracket that reinforces the parcel shelf under the steering column.
Re: Can anyone identify this bracket please .....
Posted: Wed Jun 01, 2016 9:56 pm
by Galileo
Spot on, 629140
- 05-27.png (122.11 KiB) Viewed 903 times
Re: Can anyone identify this bracket please .....
Posted: Thu Jun 02, 2016 5:54 pm
by MIG Wielder
That's good. Thank you very much everyone.
Just off to post it on the FreeBee section of the board.
Cheers All,
Tony.