The Triumph Dolomite Club - Discussion Forum

Can someone please put up a photo of the choke trunnion as it fits into the carb?

I forgot to photograph mine and it then promptly fell out never to be seen again.

ham204 wrote:Can someone please put up a photo of the choke trunnion as it fits into the carb?

I forgot to photograph mine and it then promptly fell out never to be seen again.

Ham

here you are http://www.rimmerbros.co.uk/Item--i-AUE34

Paul

Thanks Paul,

That's it? No washers or anything else?

ham204 wrote:Thanks Paul,

That's it? No washers or anything else?

No washers or pins etc, the choke cable goes through the hole and is secured in place to prevent it slipping via that small retaining screw, same idea as the screw on the heater fan box under the bonnet and the bonnet catch.

Paul

I suggest you purchase a section of 15amp electrical chocolate block and use one of the connectors.

I purchased this, originally for the MGB but works perfectly for the HS6 carb