Page 1 of 1
Automatic Accelerator/Bulkhead Strengtheners
Posted: Thu Jun 15, 2017 10:14 pm
by xvivalve
In response to a request, I've had a limited number of these made again.
They are a tenner inc postage.
Re: Automatic Accelerator/Bulkhead Strengtheners
Posted: Thu Jun 15, 2017 10:53 pm
by new to this
Alun
What do they do,any pictures,is it common problem,
Dave
Re: Automatic Accelerator/Bulkhead Strengtheners
Posted: Fri Jun 16, 2017 12:08 am
by Maidstonerob
new to this wrote: ↑Thu Jun 15, 2017 10:53 pm
Alun
What do they do,any pictures,is it common problem,
Dave
They reinforce the mount for the throttle pedal.which can fracture due to its proximity to the wiring loom grommet. Standard fit for autos but was a must have on my manual as the pedal was flapping all over after I stressed it replacing the rubber
Re: Automatic Accelerator/Bulkhead Strengtheners
Posted: Fri Jun 16, 2017 6:51 am
by xvivalve
Re: Automatic Accelerator/Bulkhead Strengtheners
Posted: Fri Jun 16, 2017 10:36 am
by Bumpa
Alun, I'll take one of these strengtheners please. I will PM you.
Re: Automatic Accelerator/Bulkhead Strengtheners
Posted: Fri Jun 16, 2017 5:26 pm
by GTS290N
Yes please Alun, one of.
Re: Automatic Accelerator/Bulkhead Strengtheners
Posted: Sat Jun 17, 2017 4:28 pm
by Carledo
I can thoroughly recommend these, even though my bulkhead on the Carledo had not yet cracked, it flexed quite badly in use, so I used one in a prophylactic manner, works a treat, better throttle response too!
Steve