Page 1 of 1
Sloppy Gear Lever
Posted: Mon Aug 28, 2017 12:25 pm
by Neil Duke
Is there a quickshift kit?My gearlever is very sloppy,I know its not a Ford,but it could be better.
Hello and .....
Posted: Mon Aug 28, 2017 1:26 pm
by sprint95m
Welcome to the forum.
Which model of car have you got?
There are several gearboxes used.
Ian.
PS I have moved this to "Dolomite Related" as this is a more used section of the forum.
Re: Sloppy Gear Lever
Posted: Mon Aug 28, 2017 4:20 pm
by Neil Duke
Sorry,79 Sprint.
Re: Sloppy Gear Lever
Posted: Mon Aug 28, 2017 5:53 pm
by xvivalve
The Sprint gear lever is secured with a sprung bayonet cap that is then secured with a bolt. I have seen cases where the bolt missing can cause the bayonet cap to undo itself; I have also seen cars reassembled without the spring beneath the cap, both of which can cause a lose stick, or even the end of it to jump out of the remote box. The end of the stick has a small blind hole that receives a sprung plunger; this is more often than not missing as it is a right bugger to install correctly, but that itself causes minimal slop.
Correctly assembled, the Sprint stick should be tight and fairly precise; I suggest you lift the coin tray and rubber gaitor and see what is amiss. I've had some very high mileage cars but never found one with an unduly worn stick or selector rods in the remote box.
Re: Sloppy Gear Lever
Posted: Mon Aug 28, 2017 8:41 pm
by Neil Duke
Thanks,will check tomorrow night.
Re: Sloppy Gear Lever
Posted: Mon Aug 28, 2017 8:56 pm
by xvivalve
Neil, my apologies; welcome, I didn't notice this was your first post!
Is the car a recent acquisition?
Re: Sloppy Gear Lever
Posted: Tue Aug 29, 2017 12:45 pm
by Neil Duke
It is.Just trying it for size,bought it off e bay.I have got a Stag in the garage,& fancy getting a TR6 as well.Funny,my race cars are all Ford.
Probably be back with lots of silly questions.