Not a huge amount to update at the moment I am afraid, I have been somewhat hampered by the weather and getting the slant engine stand mounts done.
The first thing that needed doing was to get the structure sound so I can get the dolly mounted onto the jacking points then move on to the chassis legs.
First job then finish stripping the paint from the wings.
Good, no filler!
I cut the bottoms of the wings to check the front of the sills, they have been repaired in the past, the repair is fine, but not up to the standard that I am looking for so I will cut it off and re do it in zintec sheet.
The wing bottom itself is not so good, I'll have to think about a replacement one of these, probably on both sides.
Although the sills looked ok from the outside, shining a torch down the inside of them revealed some past repairs so replacement here is the best option, along with the lower section as well.
The reinforcer will need some repairs, nothing too drastic.
With some repairs it all should go back together quite nicely.
This is what I meant by previous repairs!
I should be able to get the jacking points repaired and the sills on this Friday and move on to the other side.