The Triumph Dolomite Club - Discussion Forum

Check this out!

Triumph Dolomite SPRINT** BULKHEAD INSULATION PAD - In Engine Bay NEW **RHD cars https://rover.ebay.com/rover/0/0/0?mpre ... 3308367961

Try Aldridge. That's where I got the one for XJX. https://forum.triumphdolomite.co.uk/vie ... &start=180 scroll down.

Here is a pic of the Aldridge one fitted to my sprint
What I did do as it is an absorbent material, was to cut channels out of the back and then line with builders silicone. I did this to where the drain holes are and where the water is likely to flow.

I have half an original one but unfortunately I think what is buried in the garage is the fan side.

80Sprint wrote: ↑Wed Aug 14, 2019 8:46 pm I have half an original one but unfortunately I think what is buried in the garage is the fan side.

Thanks but it's the driver side i need

Dave

I think you would struggle, certainly with the contact adhesive I used.
You haven’t got long and only one go at it.

I have an early moulded original, though it's taken from an 1850 auto. It's complete, but some of the thin bits between holes are fragile...

xvivalve wrote: ↑Fri Aug 16, 2019 10:35 am I have an early moulded original, though it's taken from an 1850 auto. It's complete, but some of the thin bits between holes are fragile...

Alunn

Thanks that would be good

Thanks Dave