The Triumph Dolomite Club - Discussion Forum

I am at the stage of putting a floor in the dodgem mower. The span of the floor is about 830mm. The length is about 800mm. It will be carried on a frame of 25mm square box section, the spacing of which is as yet not finalised. I would appreciate any advice on the thickness of sheet steel I should use. Also with respect to the spacing of the box section. I had 1mm in mind for the sheet steel. Many thanks.
Regards,
Richard

1mm sheet should be fine. I'd give a box perimeter at least one central brace bar or maybe a cross and attach the floor to it with rivets or similar, not so much for strength as to stop it bowing and booming if unsupported.

Steve

Many thanks Steve.
Regards,
Richard