Page 1 of 1
Hole measurements in lower front panel. To take over rider supports.
Posted: Fri Oct 02, 2020 3:02 pm
by DJP
Hi all,
Just thought while James was in the mood for measuring, could he give a definitive measurement for the two holes in the bottom front panel to take the over rider supports. I have an early car that at some point has had a later panel without holes. Also the hole size.
Thanks in advance. Dave.
Re: Hole measurements in lower front panel. To take over rider supports.
Posted: Fri Oct 02, 2020 4:34 pm
by RSi
DJP wrote: ↑Fri Oct 02, 2020 3:02 pm
Hi all,
Just thought while James was in the mood for measuring, could he give a definitive measurement for the two holes in the bottom front panel to take the over rider supports. I have an early car that at some point has had a later panel without holes. Also the hole size.
Thanks in advance. Dave.
Check out James' thread mate, he should be able to help you.
https://forum.triumphdolomite.co.uk/vie ... 7&start=45
Re: Hole measurements in lower front panel. To take over rider supports.
Posted: Fri Oct 02, 2020 6:33 pm
by James467
DJP wrote: ↑Fri Oct 02, 2020 3:02 pm
Hi all,
Just thought while James was in the mood for measuring, could he give a definitive measurement for the two holes in the bottom front panel to take the over rider supports. I have an early car that at some point has had a later panel without holes. Also the hole size.
Thanks in advance. Dave.
I can do that Dave, I'll take them again from Lees car and add them into the first post. They are in the link somewhere that Murdo posted when I did Shaun's car.
Re: Hole measurements in lower front panel. To take over rider supports.
Posted: Fri Oct 02, 2020 10:59 pm
by RSi
I checked the post again and found this, I think this may be them.
Re: Hole measurements in lower front panel. To take over rider supports.
Posted: Sat Oct 03, 2020 10:02 am
by DJP
That’s great Murdo,
Thanks. Now it’s being brave enough to do it.