Page 1 of 1
Front shocks
Posted: Fri Oct 23, 2020 7:24 pm
by new to this
Ive got spats front shocks and the lower rubber mount needs replacement,what do i use ?
The poly for dolomites is to small there 30mm long, where mine is 31mm, i know there meant to stick out both sides, would that make any difference ?
Thanks Dave
Re: Front shocks
Posted: Sat Oct 24, 2020 9:34 am
by SprintV8
Ived literally just changed the bottom bush’s on my Spax.
Got them from Rally Design.
Yellow in colour right bugger to fit.
Used the original sleeves.
I post up the part number later.
I’m also going to get the top arm/Shock plates (Triangular) remade so they cover/support the Bush more.
Re: Front shocks
Posted: Sat Oct 24, 2020 9:36 pm
by new to this
SprintV8 wrote: ↑Sat Oct 24, 2020 9:34 am
Ived literally just changed the bottom bush’s on my Spax.
Got them from Rally Design.
Yellow in colour right bugger to fit.
Used the original sleeves.
I post up the part number later.
I’m also going to get the top arm/Shock plates (Triangular) remade so they cover/support the Bush more.
The poly bushes i bought are not right, so if you could send me the part numbers for the bushes thanks,
not sure what you mean about the top arm/shock plate ?
thanks Dave
Re: Front shocks
Posted: Mon Oct 26, 2020 11:38 pm
by SprintV8
The triangular plate is that holds the top arms Shock and ball joint.
When all bolted together doesn’t appear to fully support cover the shock lower Bush.
I’ll have a look for that part number tomorrow and post a photo of what I actually mean about that Bush.