The Triumph Dolomite Club - Discussion Forum http://forum.triumphdolomite.co.uk/ |
|
Wiring loom clips http://forum.triumphdolomite.co.uk/viewtopic.php?t=36894 |
Page 1 of 1 |
Author: | new to this [ Sat Sep 18, 2021 10:45 pm ] |
Post subject: | Wiring loom clips |
Theres clips that hold the wiring loom in place to the bulk head near the pedals under dash,how do you get them out ? Thanks Dave |
Author: | Manta [ Sun Sep 19, 2021 3:53 pm ] |
Post subject: | Re: Wiring loom clips |
With great difficulty, get a very small screwdriver, and try and prise the clips open, it should then pull off the pin, the pin is welded onto the body, |
Author: | geeksteve [ Sun Sep 19, 2021 7:45 pm ] |
Post subject: | Re: Wiring loom clips |
Quote:
the pin is welded onto the body,
When I did mine I ended up with a P-Clip with a pin in it and a hole in the body Steve |
Author: | xvivalve [ Sun Sep 19, 2021 11:28 pm ] |
Post subject: | Re: Wiring loom clips |
I use old fashioned ’pincers’ |
Author: | new to this [ Mon Sep 20, 2021 7:44 pm ] |
Post subject: | Re: Wiring loom clips |
Thanks for the replys,were these clips designed on a Friday afternoon when they came back from the pub odd things these clips,managed to get them off today and refitted after modifying them with heat shrink Dave |
Page 1 of 1 | All times are UTC+01:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |