Page 1 of 1
Wiring loom clips
Posted: Sat Sep 18, 2021 10:45 pm
by new to this
Theres clips that hold the wiring loom in place to the bulk head near the pedals under dash,how do you get them out ?
Thanks Dave
Re: Wiring loom clips
Posted: Sun Sep 19, 2021 3:53 pm
by Manta
With great difficulty, get a very small screwdriver, and try and prise the clips open, it should then pull off the pin,
the pin is welded onto the body,
Re: Wiring loom clips
Posted: Sun Sep 19, 2021 7:45 pm
by geeksteve
Manta wrote: ↑Sun Sep 19, 2021 3:53 pm
the pin is welded onto the body,
When I did mine I ended up with a P-Clip with a pin in it and a hole in the body
Steve
Re: Wiring loom clips
Posted: Sun Sep 19, 2021 11:28 pm
by xvivalve
I use old fashioned ’pincers’
Re: Wiring loom clips
Posted: Mon Sep 20, 2021 7:44 pm
by new to this
Thanks for the replys,were these clips designed on a Friday afternoon when they came back from the pub 
odd things these clips,managed to get them off today and refitted after modifying them with heat shrink
Dave