Page 1 of 1
torquatrol dolo sprint
Posted: Thu Jun 23, 2022 6:13 pm
by Denis Bonnier
dear TDC members,
I am looking for information on the method of replacing torquatrol with a new torquatrol. do you need a hydraulic press or a puller?
thanks in advance
Denis
Re: torquatrol dolo sprint
Posted: Thu Jun 23, 2022 6:24 pm
by xvivalve
Hi Denis,
A manual three legged puller is more than adequate. When fitting the new unit be sure to also fit a new tolerance ring which is the corrugated stainless steel cylinder which sits between the torquatrol unit and the spindle on which it is mounted.
Re: torquatrol dolo sprint
Posted: Fri Jun 24, 2022 8:05 am
by Denis Bonnier
xvivalve,
and for reassembly?
is the operation easy?
the assembly on its axis is tight? Thanks again
Re: torquatrol dolo sprint
Posted: Fri Jun 24, 2022 12:12 pm
by xvivalve
It presses on easily enough; put the new tolerance ring on the spindle first.
Re: torquatrol dolo sprint
Posted: Fri Jun 24, 2022 2:45 pm
by Denis Bonnier
That's it, I removed the torquetrol from its axis as well as the ring.
If I want to remove the pulley shaft to change the bearings, how should I proceed?
Re: torquatrol dolo sprint
Posted: Fri Jun 24, 2022 3:06 pm
by xvivalve
I have been unable to locate replacement pulley shaft bearings