90’s Rover 400 seats into Toledo.
Posted: Mon Dec 30, 2024 2:32 pm
A few months back, I decided to change the seats in the Toledo - Purely based on the facts that I am over 6 foot tall and the original (non reclining) seats are just too uncomfortable. So I purchased a set of front seats from a mid to late 1990’s Rover 400 that was heading for the crusher.
After making a new bracket (lots of welding required and finding strong metal), it was carefully measured so in that would go in line with the existing floor pan holes.
The new seats are on progress, the passenger side is now in the car and now to repeat the entire process with the driver side seat!
After making a new bracket (lots of welding required and finding strong metal), it was carefully measured so in that would go in line with the existing floor pan holes.
The new seats are on progress, the passenger side is now in the car and now to repeat the entire process with the driver side seat!