The Triumph Dolomite Club - EzBoard Archive

Hello everyone<br>
Just fitted a magnatronic ignition system today and replaced plugs(unipart ones)<br>
All went well and I was pretty proud of myself (not being the mechanical type)<br>
BUT - the engine revs are now higher at idle. Used to be about 800-900 now 1200. Is this to be expected after fitting the new ignition and do I now need to adjust the timing?<br>
The car runs well though.<br>
<br>
And for those that answered my last question about the fuel hose replacement, thanks. Replacing that went well too. Replaced all pieces around the carbs. They weren't that bad when I got them off but a bit of planned preventative maintainence never hurt anyone, so they say. I replaced them with some that I bought from Halfords made by Goodyear.

<p></p><i></i>

Trying to think back to when I did mine, I think the timing does advance a bit so you'll need to tweak it back.<br>
<br>
Martin

<p><!--EZCODE LINK START--><a href="http://www.dolomitesprint.com/" target="top">www.dolomitesprint.com</a><!--EZCODE LINK END--></p><i></i>

Is this likely to also be the cause of my running-on problem??

<p></p><i></i>

Yes, you will need to tweek the timing. I have also just fitted a Magnetronic system and I had to rotate my distributor anticlockwise as the timing was out by about 6 degrees (on the timing marks). I only just had enough room as the vacuum advance ended up touching some adjacent components.

<p></p><i></i>

Has anyone got a timing quadrant knocking around? Seems to be missing from my car...

<p></p><i></i>

...send me your address (mine's in the back of the magazine) and it'll be with you in a jiffy (literally)... nominal donation to Cancer Research or the Woodland Trust

<p></p><i></i>

Thanks Alan, much appreciated. <br>
<br>
James Skinner<br>
17 Primrose Way<br>
Chippenham<br>
SN14 6XW<br>


<p></p><i></i>