The last part of project Bruce is issued today.
More extensive rot to the sill in hindsight I would have replaced the whole thing with repair panels.

The end of the sill got a plate and some underseal.

The completed forward structure of the front of the sill all nice and solid.

Nicely undersealed ready for the wing to go on
Oh joy more unforseen rot nice plate at the back of the sill sorted that one

welded inn

Wings back on and a nice skim coat of filler to smooth it all up
Then work started on the engine bay. Strut was removed and the casing pulled back into place. The seams where then welded back down and a plate was applied at the back of the strut. A layer of sealant finished it off

The same was then done on the other side.
After that we tackled some other general holes which where done to put the MOT tester in a good mood.
Bonnet corner

Other places where some of the wheel arches and the top of the wing and A pillar.
Then on went the paint.
Sill

Then I got creative Bruce got some fetching eyebrows and the black paint was extended around the arch.
All outside washed and waiting for an MOT tomorrow fingers crossed.
Need to get some green paint made up to cover the grey patch and then after a nice polish this car might just start to look the part!
Hope you enjoyed the update as it took an hour to type.
Paul