Changing distributor
Re: Changing distributor
My sentiments exactly, I fitted £35 Accuspark to my ac delco dizzy, works a treat.
- HQentity
- Guest contributor
- Posts: 309
- Joined: Mon Jan 05, 2015 12:42 pm
- Location: Ashington, West Sussex
Re: Changing distributor
I'm changing the dizzy because I was getting quite a bit of timing scatter. Also the springs are a tad bent so the timing curve is pants!
To be honest I know the 1850 dizzy gets a bad wrap, but after yesterday, I can't sing their praises highly enough. Better the devil you know!

To be honest I know the 1850 dizzy gets a bad wrap, but after yesterday, I can't sing their praises highly enough. Better the devil you know!

HQentity (Kyle)
1975 TRIUMPH DOLOMITE 1850 in Honeysuckle (Nina) 2015-2020

"The harder the conflict, the more glorious the Triumph." - Thomas Paine
1975 TRIUMPH DOLOMITE 1850 in Honeysuckle (Nina) 2015-2020

"The harder the conflict, the more glorious the Triumph." - Thomas Paine
Re: Changing distributor
Hello,
My dad has a 1976 dolomite 1850. It has a delco distributor. I am after an electronic ignition kit for him. I have seen a few around, but am not sure they are for his distributor ( AC 300, AC 302, AC 303? ), I have no idea of the part number. What was the Accuspark kit you used, and where did you get it?
My dad has a 1976 dolomite 1850. It has a delco distributor. I am after an electronic ignition kit for him. I have seen a few around, but am not sure they are for his distributor ( AC 300, AC 302, AC 303? ), I have no idea of the part number. What was the Accuspark kit you used, and where did you get it?
Re: Changing distributor
Click below. The distributor must be removed from the car to fit this kit.DigbyJones wrote:Hello,
My dad has a 1976 dolomite 1850. It has a delco distributor. I am after an electronic ignition kit for him. I have seen a few around, but am not sure they are for his distributor ( AC 300, AC 302, AC 303? ), I have no idea of the part number. What was the Accuspark kit you used, and where did you get it?
http://www.romancart.com/information.as ... oBFg4cDhhc
-
- Guest contributor
- Posts: 11179
- Joined: Tue Oct 03, 2006 9:45 pm
- Location: Middlesex
Re: Changing distributor
The long hexagonal pole drives the oil pump and is ABSOLUTELY CRUCIAL....
DO NOT run your engine again unless you are absolutely sure its correctly engaged with the oil pump.
Disconnect ignition, remove oil pressure warning light switch, spin starter...if you dont see a squirt of oil
then panic...
Jonners
DO NOT run your engine again unless you are absolutely sure its correctly engaged with the oil pump.
Disconnect ignition, remove oil pressure warning light switch, spin starter...if you dont see a squirt of oil
then panic...
Jonners
Note from Admin: sadly Jon passed away in February 2018 but his humour and wealth of knowledge will be fondly remembered by all. RIP Jonners.
- HQentity
- Guest contributor
- Posts: 309
- Joined: Mon Jan 05, 2015 12:42 pm
- Location: Ashington, West Sussex
Re: Changing distributor
Hiya Jon, I ran the car for quite a long journey today, it ran fine with no overheating, so I'm reasonably confident it's alright?!! I hope so! If ever I take anything out I try to make sure I put it back as it was! 

HQentity (Kyle)
1975 TRIUMPH DOLOMITE 1850 in Honeysuckle (Nina) 2015-2020

"The harder the conflict, the more glorious the Triumph." - Thomas Paine
1975 TRIUMPH DOLOMITE 1850 in Honeysuckle (Nina) 2015-2020

"The harder the conflict, the more glorious the Triumph." - Thomas Paine
-
- TDC Member
- Posts: 2338
- Joined: Sun Mar 16, 2008 2:52 pm
... but is it a good idea ...?
I had another look at this swapping-the1850-A.C.-Delco-distributor- for-the-Lucas-44D4 unit today.
I'm not convinced it's a good idea looking at the data in the workshop manuals.
Yes; It'll fit.
Yes; It'll "work" ; but it won't be optimum for the engine.
The 1850 8 valve and the Sprint 16 valve units are very different.
The A.C. Delco dizzy is much better specified than the Lucas unit for a start..
And there are 3 different types of Lucas 44D4 Sprint distributors.
Type A 313177
Type B RKC 0695
Type C RKC 3034
I took as "typical" the Type A unit.
From the data below you can see the following.....
The centrifugal advance is on average less on the Sprint than the 1850 Delco Unit.
The A.C. Delco unit has a limit on maximum centrifugal advance.
This isn't specified on the Lucas Sprint unit.
The vacuum advance is a lot higher on the 1850 A.C. Delco unit cruising at 70mph or ~ 3000 rpm compared with the Sprint Lucas unit. This is to do with 70mph fuel economy on the 1850.
Given the choice of a well worn A.C. Delco unit or a new Lucas unit, it might be better to use the Lucas unit with the select-on-test advance springs that Moss do. What you do with the vacuum bit I'm not sure.
Tony.
Edit: 2/06/20 updated graphs and corrected table for A spec dizzy.
I'm not convinced it's a good idea looking at the data in the workshop manuals.
Yes; It'll fit.
Yes; It'll "work" ; but it won't be optimum for the engine.
The 1850 8 valve and the Sprint 16 valve units are very different.
The A.C. Delco dizzy is much better specified than the Lucas unit for a start..
And there are 3 different types of Lucas 44D4 Sprint distributors.
Type A 313177
Type B RKC 0695
Type C RKC 3034
I took as "typical" the Type A unit.
From the data below you can see the following.....
The centrifugal advance is on average less on the Sprint than the 1850 Delco Unit.
The A.C. Delco unit has a limit on maximum centrifugal advance.
This isn't specified on the Lucas Sprint unit.
The vacuum advance is a lot higher on the 1850 A.C. Delco unit cruising at 70mph or ~ 3000 rpm compared with the Sprint Lucas unit. This is to do with 70mph fuel economy on the 1850.
Given the choice of a well worn A.C. Delco unit or a new Lucas unit, it might be better to use the Lucas unit with the select-on-test advance springs that Moss do. What you do with the vacuum bit I'm not sure.
Tony.
Edit: 2/06/20 updated graphs and corrected table for A spec dizzy.
- Attachments
-
- Sprint 1850 compV2.png (11.26 KiB) Viewed 715 times
Last edited by MIG Wielder on Tue Jun 02, 2020 5:00 pm, edited 2 times in total.
- HQentity
- Guest contributor
- Posts: 309
- Joined: Mon Jan 05, 2015 12:42 pm
- Location: Ashington, West Sussex
Re: Changing distributor
Very interesting Tony, thanks for that. I didn't realise it was such a significant change as that? How is it that the 1850's run so well with the Lucas dizzy I wonder?!? I still have the slight missing at low revs occasionally at the moment with the 1850 dizzy, beginning to wonder if I should look to the carbs instead though! Thanks for the info 

HQentity (Kyle)
1975 TRIUMPH DOLOMITE 1850 in Honeysuckle (Nina) 2015-2020

"The harder the conflict, the more glorious the Triumph." - Thomas Paine
1975 TRIUMPH DOLOMITE 1850 in Honeysuckle (Nina) 2015-2020

"The harder the conflict, the more glorious the Triumph." - Thomas Paine
- Toledo Man
- Guest contributor
- Posts: 7542
- Joined: Tue Oct 03, 2006 5:52 pm
- Location: Halifax, West Yorkshire
- Contact:
Re: Changing distributor
Tony, I didn't know there was such a big difference in the advance curve between the Delco and the Lucas 44D4 dizzy. I knew that there was a difference and mine is running fine. The main benefits in my eyes are the improved reliability and the easier access to the points (should I wish to run them).
Kyle, whichever dizzy you decide to use, make sure the ignition is 100% before looking at the carbs.
Kyle, whichever dizzy you decide to use, make sure the ignition is 100% before looking at the carbs.
Toledo Man
West Yorkshire Area Organiser
Meetings take place on the first Wednesday of the month at 8.00pm at The Railway, 1 Birstall Lane, Drighlington, Bradford, BD11 1JJ
2003 Volvo XC90 D5 SE (PX53 OVZ - The daily driver)
2009 Mercedes-Benz W204 C200 CDI Sport (BJ58 NCV - The 2nd car)
1991 Toyota Celica GT (J481 ONB - a project car)
Former stable of SAY 414M (1974 Toledo), GRH 244D (1966 1300fwd), CDB 324L (1973 1500fwd), GGN 573J (1971 1500fwd), DCP 625S (1977 Dolomite 1300) & LCG 367N (1975 Dolomite Sprint), NYE 751L (1972 Dolomite 1850 auto) plus 5 Acclaims and that's just the Triumphs!
Check my blog at http://triumphtoledo.blogspot.com
My YouTube Channel with a bit of Dolomite content.
"There is only one way to avoid criticsm: Do nothing, say nothing and BE nothing." Aristotle
West Yorkshire Area Organiser
Meetings take place on the first Wednesday of the month at 8.00pm at The Railway, 1 Birstall Lane, Drighlington, Bradford, BD11 1JJ
2003 Volvo XC90 D5 SE (PX53 OVZ - The daily driver)
2009 Mercedes-Benz W204 C200 CDI Sport (BJ58 NCV - The 2nd car)
1991 Toyota Celica GT (J481 ONB - a project car)
Former stable of SAY 414M (1974 Toledo), GRH 244D (1966 1300fwd), CDB 324L (1973 1500fwd), GGN 573J (1971 1500fwd), DCP 625S (1977 Dolomite 1300) & LCG 367N (1975 Dolomite Sprint), NYE 751L (1972 Dolomite 1850 auto) plus 5 Acclaims and that's just the Triumphs!
Check my blog at http://triumphtoledo.blogspot.com
My YouTube Channel with a bit of Dolomite content.
"There is only one way to avoid criticsm: Do nothing, say nothing and BE nothing." Aristotle
-
- Guest contributor
- Posts: 11179
- Joined: Tue Oct 03, 2006 9:45 pm
- Location: Middlesex
Re: Changing distributor
Are you sure the oil light goes out if its working?
I'm not convinced they actually do run better.
Dave's car is an auto and doesnt by his own admission do a lot of motorway stuff.
My car is TR7'ed and I run it more advanced to cope with the lack of advance over the delco unit.
I may well stick a Delco with accuspark back in in due course...
Jonners
I'm not convinced they actually do run better.
Dave's car is an auto and doesnt by his own admission do a lot of motorway stuff.
My car is TR7'ed and I run it more advanced to cope with the lack of advance over the delco unit.
I may well stick a Delco with accuspark back in in due course...
Jonners
Note from Admin: sadly Jon passed away in February 2018 but his humour and wealth of knowledge will be fondly remembered by all. RIP Jonners.