Guys
My dashboard speaker grill clips are missing - the lugs on the grill are there, the plastic trim that these lugs push into are missing and the they are NLA has anybody come up with alternative.
Paul
Dashboard Speaker Grill rentension
-
Flyfisherman
- Guest contributor
- Posts: 980
- Joined: Sat Sep 04, 2010 10:42 am
-
SprintMWU773V
- TDC Staffs Area Organiser
- Posts: 5429
- Joined: Wed Oct 18, 2006 2:08 pm
- Location: The Old Asylum
Re: Dashboard Speaker Grill rentension
The best solution I have found is blue tack. Stick some in the holes and then push the grille into it. it won't rattle around and it's easy to remove. I thought I'd bought some correct retainers but when I went to fit them I found they were wrong.
Mark
1961 Chevrolet Corvair Greenbrier Sportswagon
1980 Dolomite Sprint project using brand new shell
2009 Mazda MX5 2.0 Sport
2018 Infiniti Q30
1961 Chevrolet Corvair Greenbrier Sportswagon
1980 Dolomite Sprint project using brand new shell
2009 Mazda MX5 2.0 Sport
2018 Infiniti Q30
Re: Dashboard Speaker Grill rentension
On mine a blue rawlplug (the one bigger than a brown) provided a solution. The plug is a push fit in the dash hole and the speaker grille pin pushes into the centre hole.
Re: Dashboard Speaker Grill rentension
Have the same problem, going over bumps the grill jumps a bit.
I was going to try some grommets, but other jobs have been more pressing,
will check tonight.
I was going to try some grommets, but other jobs have been more pressing,
will check tonight.
NRW 581W Sprint
On the motorway no one can hear me sing!
Construed as a public service, self preservation in reality.
On the motorway no one can hear me sing!
Construed as a public service, self preservation in reality.
Re: Dashboard Speaker Grill rentension
Managed to find the grommet assortment,
and used a half inch blanking grommet, and pushed a flat blade screwdriver through.
It's a bit of a faff putting the grommet in, but it won't come out unless intended.
and used a half inch blanking grommet, and pushed a flat blade screwdriver through.
It's a bit of a faff putting the grommet in, but it won't come out unless intended.
- 2016-08-21 11.53.51.jpg (138.13 KiB) Viewed 998 times
NRW 581W Sprint
On the motorway no one can hear me sing!
Construed as a public service, self preservation in reality.
On the motorway no one can hear me sing!
Construed as a public service, self preservation in reality.
Re: Dashboard Speaker Grill rentension
Now that is a very good idea!..Thanks for sharing it..Mahesh wrote:Managed to find the grommet assortment,
and used a half inch blanking grommet, and pushed a flat blade screwdriver through.
It's a bit of a faff putting the grommet in, but it won't come out unless intended.
