Hi All,
I have a Dolly fully stripped down, axle off, engine out, etc etc and it is just a shell on axle stands. I am loosing the storage at the end of October and and need to be able to roll the shell out on to a low loader for removing to new storage. Does anyone have a dolly jig on wheel that I could either borrow for a short time or maybe buy off them one they have used before and no longer need.
Please let em know asap. I am looking to be able to bolt the moveable jig to the front subframe mounts and the rear trailing mounts. Hope this is a clear description.
Many thanks
Dennis
Jig required for Triumph Dolomite Sprint
-
xvivalve
- TDC West Mids Area Organiser
- Posts: 13582
- Joined: Thu Sep 28, 2006 1:13 pm
- Location: Over here...can't you see me?
Re: Jig required for Triumph Dolomite Sprint
I was going to bid myself, then I realised the bodyshell wasn't included!
-
xvivalve
- TDC West Mids Area Organiser
- Posts: 13582
- Joined: Thu Sep 28, 2006 1:13 pm
- Location: Over here...can't you see me?
Re: Jig required for Triumph Dolomite Sprint
I'll not bid on this, seeing your current need is greater than mine, but I'll happily buy it from you when you've finished with it...