Bulk head insulation

[new to this]

Can you buy new engine bulk head insulation,mines rotted away by the servo,and can you fit one of the engine is still in place

Thanks Dave

[sprintchris]

Check this out!

Triumph Dolomite SPRINT** BULKHEAD INSULATION PAD - In Engine Bay NEW **RHD cars https://rover.ebay.com/rover/0/0/0?mpre ... 3308367961

[Mad Mart]

Try Aldridge. That's where I got the one for XJX. https://forum.triumphdolomite.co.uk/vie ... &start=180 scroll down.

[oily66]

Here is a pic of the Aldridge one fitted to my sprint
What I did do as it is an absorbent material, was to cut channels out of the back and then line with builders silicone. I did this to where the drain holes are and where the water is likely to flow.

[80Sprint]

I have half an original one but unfortunately I think what is buried in the garage is the fan side.

[new to this]

I have half an original one but unfortunately I think what is buried in the garage is the fan side.

Thanks but it's the driver side i need

Dave

[new to this]

Thank for the replys,didn't know you could buy them ,there not cheap
Is it possible to fit with engine in place

[oily66]

I think you would struggle, certainly with the contact adhesive I used.
You haven’t got long and only one go at it.

[xvivalve]

I have an early moulded original, though it's taken from an 1850 auto. It's complete, but some of the thin bits between holes are fragile...

[new to this]

I have an early moulded original, though it's taken from an 1850 auto. It's complete, but some of the thin bits between holes are fragile...

Alunn

Thanks that would be good

Thanks Dave