Jet washer

[new to this]

has any one been able to repair the Jet Washer mines come loose ?

Thanks Dave

[cliftyhanger]

has any one been able to repair the Jet Washer mines come loose ?

Thanks Dave

Jb weld did mine 10 years ago. I reckon any decent epoxy will do the trick, just clean everything well first

[Richard the old one]

I agree as I have had to use epoxy resin on most of mine.

[new to this]

has any one been able to repair the Jet Washer mines come loose ?

Thanks Dave

Jb weld did mine 10 years ago. I reckon any decent epoxy will do the trick, just clean everything well first

Thanks hadnt thought about glues, i did try welding it but it didnt take on the brass part

thanks Dave

[new to this]

I agree as I have had to use epoxy resin on most of mine.

Thanks Dave

[oily66]

I thought the brass tube was loose to enable positioning the jet, by swivelling it.
If you hold the brass tube then reposition the hose then it holds it in the position.
If I’m wrong then I need to recrimp mine into place??

[new to this]

I thought the brass tube was loose to enable positioning the jet, by swivelling it.
If you hold the brass tube then reposition the hose then it holds it in the position.
If I’m wrong then I need to recrimp mine into place??

My jet washer on the passengers side is fixed so think there meant to be fixed,the jet washer on drivers side is the one that moves

Dave

[new to this]

In the end I decided to braze it,this was the first time I've brazed not the neatiest but worked

Dave