Front shocks

[new to this]

Ive got spats front shocks and the lower rubber mount needs replacement,what do i use ?

The poly for dolomites is to small there 30mm long, where mine is 31mm, i know there meant to stick out both sides, would that make any difference ?

Thanks Dave

[SprintV8]

Ived literally just changed the bottom bush’s on my Spax.
Got them from Rally Design.
Yellow in colour right bugger to fit.
Used the original sleeves.
I post up the part number later.

I’m also going to get the top arm/Shock plates (Triangular) remade so they cover/support the Bush more.

[new to this]

Ived literally just changed the bottom bush’s on my Spax.
Got them from Rally Design.
Yellow in colour right bugger to fit.
Used the original sleeves.
I post up the part number later.

I’m also going to get the top arm/Shock plates (Triangular) remade so they cover/support the Bush more.

The poly bushes i bought are not right, so if you could send me the part numbers for the bushes thanks,

not sure what you mean about the top arm/shock plate ?

thanks Dave

[SprintV8]

The triangular plate is that holds the top arms Shock and ball joint.
When all bolted together doesn’t appear to fully support cover the shock lower Bush.

I’ll have a look for that part number tomorrow and post a photo of what I actually mean about that Bush.