Rear Screen Vent Panel

[xvivalve]

I came across the GRP moulds for the rear screen vent panel in my lock up recently and reminded myself that being a sandwich mould to give two finished flat surfaces it had been relatively expensive to have made. So far, we’ve only had two orders for this panel, so knowing the fabricator was not particularly busy, I had a couple of panels made so this is a reminder that they’re available. The beauty of this panel being GRP is the potential to fit it without welding and therefore the ability to leave a vinyl roof in place! As with all other Club GRP products, the mould was cast off an OE new old stock metal panel.