Cluning noise from rear end

For everything to do with Dolomites, Toledos, FWD cars and Dolomite-based kitcars.
Post Reply
Message
Author
User avatar
ham204
Guest contributor
Guest contributor
Posts: 246
Joined: Fri Jan 06, 2017 11:14 pm

Cluning noise from rear end

#1 Post by ham204 »

Recently I have been hearing a 'clunk, clunk' noise from the rear end of my Sprint when I try to drive off. It usually happens when the car has been driven for some time and almost always when I drive off on an uphill gradient, the steeper the more 'clunkier' it becomes. By 'clunking' I mean a heavy metal on metal noise. Once I drive off, the car acts normally. Last Sunday it had a particularly bad case of 'clunking' and decided to keep it garaged until I sort out the problem. The car has new UJ's, rear suspension bushes all round plus GAZ adjustable shocks.

Is it a case of diff rebuild?
1972 Spitfire MK IV
1972 Stag
1980 Sprint

1962 Land Rover Series 2a
1961 Land Rover Series 2a (under restoration)
1983 Land Rover Series 3

1995 Suzuki Samurai SJ413

1972 MGB GT (banished for being too tight to fit in it)
dollyman
TDC Cheshire Area Organiser
Posts: 1410
Joined: Wed May 17, 2017 6:28 pm
Location: NANTWICH.

Re: Cluning noise from rear end

#2 Post by dollyman »

The fact it has new uj's suggests one has failed, it wouldn't be the first time.....

Tony.
NOW A CLUB MEMBER 2017057 :bluewave:
User avatar
yorkshire_spam
Guest contributor
Guest contributor
Posts: 994
Joined: Wed Nov 15, 2017 3:35 pm
Location: Filey, North Yorkshire

Re: Cluning noise from rear end

#3 Post by yorkshire_spam »

Is it a single "clunk" on take-up or a repeated clunk-clunk at the frequency related to road speed?
A repeated clunk-clunk-clunk at road speed would suggest a rotating component like CV/UJ in the propshaft or maybe a knackered carrier bearing on the prop allowing the start-off torque of the prop to deflect it far beyond normal operation.
A single clunk - maybe diff, or even a very knackered bush in a suspension arm?
Image
User avatar
ham204
Guest contributor
Guest contributor
Posts: 246
Joined: Fri Jan 06, 2017 11:14 pm

Re: Cluning noise from rear end

#4 Post by ham204 »

dollyman wrote: Fri Feb 11, 2022 10:33 am The fact it has new uj's suggests one has failed, it wouldn't be the first time.....

Tony.
Yes that's possible - will check over the weekend. Cheers
1972 Spitfire MK IV
1972 Stag
1980 Sprint

1962 Land Rover Series 2a
1961 Land Rover Series 2a (under restoration)
1983 Land Rover Series 3

1995 Suzuki Samurai SJ413

1972 MGB GT (banished for being too tight to fit in it)
User avatar
ham204
Guest contributor
Guest contributor
Posts: 246
Joined: Fri Jan 06, 2017 11:14 pm

Re: Cluning noise from rear end

#5 Post by ham204 »

yorkshire_spam wrote: Fri Feb 11, 2022 10:48 am Is it a single "clunk" on take-up or a repeated clunk-clunk at the frequency related to road speed?
A repeated clunk-clunk-clunk at road speed would suggest a rotating component like CV/UJ in the propshaft or maybe a knackered carrier bearing on the prop allowing the start-off torque of the prop to deflect it far beyond normal operation.
A single clunk - maybe diff, or even a very knackered bush in a suspension arm?
More like a 'clunk - clunk' as I release the clutch to drive off and then it stops as I pick up speed. It does this only on an uphill road. On a level surface, it goes just fine. I will check the UJ's though
1972 Spitfire MK IV
1972 Stag
1980 Sprint

1962 Land Rover Series 2a
1961 Land Rover Series 2a (under restoration)
1983 Land Rover Series 3

1995 Suzuki Samurai SJ413

1972 MGB GT (banished for being too tight to fit in it)
cliftyhanger
TDC Member
Posts: 2541
Joined: Sun Oct 26, 2008 7:26 am

Re: Cluning noise from rear end

#6 Post by cliftyhanger »

Yes, time to get it in the air and a couple of levers to check stuff. In fact everything that moves at the rear, plus the prop.
Clive Senior
Brighton
User avatar
ham204
Guest contributor
Guest contributor
Posts: 246
Joined: Fri Jan 06, 2017 11:14 pm

Re: Cluning noise from rear end

#7 Post by ham204 »

I had a good look today and nothing seems amiss. The UJ's needed a couple of squirts of grease. The propshaft turns a little before engaging the gear in the diff. I took a video but it's too large to upload. If it was a clock face, I would say the prop turns less than 5 minutes. Is this normal?
1972 Spitfire MK IV
1972 Stag
1980 Sprint

1962 Land Rover Series 2a
1961 Land Rover Series 2a (under restoration)
1983 Land Rover Series 3

1995 Suzuki Samurai SJ413

1972 MGB GT (banished for being too tight to fit in it)
Carledo
TDC Shropshire Area Organiser
Posts: 7247
Joined: Sun Aug 21, 2011 5:12 pm
Location: Highley, Shropshire

Re: Cluning noise from rear end

#8 Post by Carledo »

30 degrees, (5 "minutes") is quite a lot of backlash, but your measurement is less than precise if you'll forgive me for saying.

I've run for years on about half that (12 degrees measured) and aside from a bit of a whine and the odd single clunk on slow takeoffs (don't do many of those) I haven't really had a problem. Nor has it got any worse, despite my blatant abuse.

I'm slightly fascinated by it being more prevalent on uphill starts. It's a bit akin to my brake line lock induced burnout loads, before I got my superhard red tie bar bushes, I used to get the axle tramping and bouncing the diff nose off the pinion snubber bush which made a horrid staccato thumping noise. Limiting the tramp stopped that.

I'd be looking hard at the tie bar bushes and the prop before condemning the diff.

Also, on the offchance, check the gearbox mount, if it's gone soggy, it could induce all sorts of noises.

Steve
'73 2 door Toledo with Vauxhall Carlton 2.0 8v engine (The Carledo)
'78 Sprint Auto with Vauxhall Omega 2.2 16v engine (The Dolomega)
'72 Triumph 1500FWD in Slate Grey, Now with RWD and Carledo powertrain!

Maverick Triumph, Servicing, Repairs, Electrical, Recomissioning, MOT prep, Trackerjack brake fitting service.
Apprentice served Triumph Specialist for 50 years. PM for more info or quotes.
cliftyhanger
TDC Member
Posts: 2541
Joined: Sun Oct 26, 2008 7:26 am

Re: Cluning noise from rear end

#9 Post by cliftyhanger »

Thinking about it, the hill start bit does make sense, in that cars often roll back a smidge. Certainly enough to open up the backlash on the diff?
That backlash is not too much of an issue, it is in the diff itself rather than the CWP (you have to carefully feel that backlash, it is really subtle and usually a degree or 2, and won't be obvious with the prop attached)

I would change the oil to something like Redline heavy shockproof, I am sure that is yellow metal safe (though not to be used in our gearboxes especially with OD) as it will do nothing but help.
Clive Senior
Brighton
User avatar
ham204
Guest contributor
Guest contributor
Posts: 246
Joined: Fri Jan 06, 2017 11:14 pm

Re: Cluning noise from rear end

#10 Post by ham204 »

cliftyhanger wrote: Mon Feb 14, 2022 8:46 am Thinking about it, the hill start bit does make sense, in that cars often roll back a smidge. Certainly enough to open up the backlash on the diff?
That backlash is not too much of an issue, it is in the diff itself rather than the CWP (you have to carefully feel that backlash, it is really subtle and usually a degree or 2, and won't be obvious with the prop attached)

I would change the oil to something like Redline heavy shockproof, I am sure that is yellow metal safe (though not to be used in our gearboxes especially with OD) as it will do nothing but help.
What is the weight of Redline heavy shockproof?
I may not find that particular brand but something similar with the same weighting. Thanks.
1972 Spitfire MK IV
1972 Stag
1980 Sprint

1962 Land Rover Series 2a
1961 Land Rover Series 2a (under restoration)
1983 Land Rover Series 3

1995 Suzuki Samurai SJ413

1972 MGB GT (banished for being too tight to fit in it)
cliftyhanger
TDC Member
Posts: 2541
Joined: Sun Oct 26, 2008 7:26 am

Re: Cluning noise from rear end

#11 Post by cliftyhanger »

ham204 wrote: Mon Feb 14, 2022 9:23 am What is the weight of Redline heavy shockproof?
I may not find that particular brand but something similar with the same weighting. Thanks.
It reckons it behaves like a 75-250, but the spec in 75-140 I believe. It doesn't thin anything like as much as normal oils.
Moss sell an 85-140 oil advertised as suitable for quietening diff a bit. That is GL5, but yellow metal safe.

I got my redline stuff off fleabay, delivered in a coupke of days, £22 all in. OK, expensive for gear oil, but it is good. And an extra tenner or so isn't a lot. (1 1/2pts of beer locally)
Clive Senior
Brighton
User avatar
ham204
Guest contributor
Guest contributor
Posts: 246
Joined: Fri Jan 06, 2017 11:14 pm

Re: Cluning noise from rear end

#12 Post by ham204 »

cliftyhanger wrote: Mon Feb 14, 2022 11:44 am
ham204 wrote: Mon Feb 14, 2022 9:23 am What is the weight of Redline heavy shockproof?
I may not find that particular brand but something similar with the same weighting. Thanks.
It reckons it behaves like a 75-250, but the spec in 75-140 I believe. It doesn't thin anything like as much as normal oils.
Moss sell an 85-140 oil advertised as suitable for quietening diff a bit. That is GL5, but yellow metal safe.

I got my redline stuff off fleabay, delivered in a coupke of days, £22 all in. OK, expensive for gear oil, but it is good. And an extra tenner or so isn't a lot. (1 1/2pts of beer locally)
Thank you! I reside in Malta and will look for it here. Cheers
1972 Spitfire MK IV
1972 Stag
1980 Sprint

1962 Land Rover Series 2a
1961 Land Rover Series 2a (under restoration)
1983 Land Rover Series 3

1995 Suzuki Samurai SJ413

1972 MGB GT (banished for being too tight to fit in it)
cliftyhanger
TDC Member
Posts: 2541
Joined: Sun Oct 26, 2008 7:26 am

Re: Cluning noise from rear end

#13 Post by cliftyhanger »

ham204 wrote: Mon Feb 14, 2022 8:43 pm Thank you! I reside in Malta and will look for it here. Cheers
Ah, that puts a different slant on it!
Clive Senior
Brighton
Manta
TDC Member
Posts: 69
Joined: Wed Jun 14, 2017 12:24 pm

Re: Cluning noise from rear end

#14 Post by Manta »

A good way to let people hear the symptoms is to upload the video clip to YouTube then put a link on here to your video,
1977 Dolomite 1850HL
1987 Opel Manta GTE
1987 Opel Manta 1800 Berlinetta.
User avatar
ham204
Guest contributor
Guest contributor
Posts: 246
Joined: Fri Jan 06, 2017 11:14 pm

Re: Cluning noise from rear end

#15 Post by ham204 »

Manta wrote: Thu Feb 17, 2022 6:53 pm A good way to let people hear the symptoms is to upload the video clip to YouTube then put a link on here to your video,
I posted the video to the FB page
1972 Spitfire MK IV
1972 Stag
1980 Sprint

1962 Land Rover Series 2a
1961 Land Rover Series 2a (under restoration)
1983 Land Rover Series 3

1995 Suzuki Samurai SJ413

1972 MGB GT (banished for being too tight to fit in it)
Post Reply