Re: A couple of leaks
Posted: Wed Jun 18, 2025 8:09 pm
Just got the cage out - fairly easily with slide hammer & 90degree fingers
cleaned it up, pushed it back on the shaft till it was home on the bearing face then
put in new o rings.
pump back in the block, still looks a little bit high to me, will see how it goes tomorrow.
thanks for the help everyone
cleaned it up, pushed it back on the shaft till it was home on the bearing face then
put in new o rings.
pump back in the block, still looks a little bit high to me, will see how it goes tomorrow.
thanks for the help everyone