The Triumph Dolomite Club - Discussion Forum

Trying to track down some clutch judder and changing the UJs on the prop shaft.

Appreciate an opinion on the centre bearing (photos) and the gearbox centre mount.

I thin the box mount looks ok but uncertain about the centre bearing

Thanks

As I think I said the box mount doesnt look tight enough.....

Jonners

Thanks for the reply. Things moved on a little from here

Decided to change it anyway, bugger to get off working on axle stand with a dodgy old body (mine not th ears)

When off the car it was soft and had gaps at the sides, replaced with a new one and happy to report everything is fine and dandy.

Judder gone

New one was even harder to get back in place, total work time around 3 hours.