Page 1 of 1

Soda blasting

Posted: Fri Mar 19, 2021 6:32 pm
by mahony
Iv'e got a front panel which has some light surface rust, any idea how much to have it soda blasted ? :D

Re: Soda blasting

Posted: Fri Mar 19, 2021 8:18 pm
by TrustNo1
soda blasting is unlikely to take rust off an older panel.

Re: Soda blasting

Posted: Fri Mar 19, 2021 8:34 pm
by mahony
TrustNo1 wrote: Fri Mar 19, 2021 8:18 pm soda blasting is unlikely to take rust off an older panel.
Ok, it's never been fitted and is a repro front panel, was going to put it on Ebay but it has some very light surface rust and i wanted to remove it and then maybe give it a coat of primer :D

Re: Soda blasting

Posted: Fri Mar 19, 2021 8:54 pm
by Tony Burd
If it's only light rust, rub it down by hand with some wet & dry, then prime.

Re: Soda blasting

Posted: Fri Mar 19, 2021 9:20 pm
by mahony
Tony Burd wrote: Fri Mar 19, 2021 8:54 pm If it's only light rust, rub it down by hand with some wet & dry, then prime.
I sort of have on the outside of the panel but it's the nook and crannies on the back i was hoping to get cleared up, maybe will give it a go with a light wire brush or a drill with a sanding flap :D

Re: Soda blasting

Posted: Fri Mar 19, 2021 11:25 pm
by TrustNo1
if you are selling it then personally I would just give it a light clean to get rid of the worse, don't paint it as most people want to see what they are buying and painting i makes it look like you are hiding rust so may put people, the buyer will likely want to get it cleaned and properly painted anyhow.

Re: Soda blasting

Posted: Sat Mar 20, 2021 9:41 am
by mahony
TrustNo1 wrote: Fri Mar 19, 2021 11:25 pm if you are selling it then personally I would just give it a light clean to get rid of the worse, don't paint it as most people want to see what they are buying and painting i makes it look like you are hiding rust so may put people, the buyer will likely want to get it cleaned and properly painted anyhow.
:thumbsup: :thumbsup: