Whats it worth?

[2F45T4U]

Before I waste my hard earned all ready spent cash on listing items on ebay that might not sell, what are all these likely to be worth?<br>
<br>
4 russet brown dolly 1300 doors, with glass and skins (one has window winder removed)<br>
<br>
1 russet brown bonnet, no rust, well there wasnt last time I saw it<br>
<br>
1300 back axle, with brakes<br>
<br>
1300 engine, 70,000 miles, no carbs, inlet manifold or fuel pump<br>
<br>
1300 gear box off above engine<br>
<br>
prop shaft<br>
<br>
rear bumper, decent nik<br>
<br>
rear heated wind screen. no scratches<br>
<br>
1300 dash board<br>
<br>
roof insulation <br>
<br>
chrome strips from around rear wind screen<br>
<br>
front suspension parts and anti roll bar<br>
<br>
front and rear lights<br>
<br>
<br>
I know I may need some of that stuff in the future but its costing me £22 a month to rent the garage there in. Lets say I needed to replace a door in 6 months time. I could probably pick one up for £20 but it would cost me £135 to store the ones I got at the moment for that length of time. Time to ditch the garage me thinks<br>
<br>
<br>
Cheers, Adam

<p></p><i></i>

[Jon Tilson]

Doors - tenner each if you get a buyer.<br>
Bonnet same<br>
Engine 25-50 quid depending on who's blown up a spit.<br>
Box - non o/d tenner. Virtually worthless.<br>
Axle...4.11 diff....mmm tener if your lucky. Worth more stripped.. Case is scrap.<br>
Small trim stuff - worth more to you. Keep it.<br>
Bumper -25 quid...but keep it.<br>
Weigh in the sub frame, keep the disks, callipers and ball joints. They are hens teeth ATM<br>
Jonners

<p></p><i></i>

[1300dolly]

Scrap the subframe<!--EZCODE EMOTICON START :rollin --><img src=http://www.ezboard.com/intl/aenglish/im ... s/roll.gif ALT=":rollin"><!--EZCODE EMOTICON END--> .I take it you are on about the brown one that jonners not seen. Post a pic to give us all a giggle<br>
I will have the headlights of you.<br>
And the engine wont sell on Ebay as there are too many going around as it is.Should have said when i saw you i could have got the all lot in my car although i would have had to leave sarah with you (fair swap?)<br>
Justyn

<p></p><i></i>

[2F45T4U]

Sarah would of had the same treatment as the 1300. In an oil sodden garage whilst coverd in old carpets <!--EZCODE EMOTICON START :lol --><img src=http://www.ezboard.com/intl/aenglish/im ... /laugh.gif ALT=":lol"><!--EZCODE EMOTICON END--> <br>
<br>
<br>
Jonners has seen the pictures before.

<p></p><i></i>

[1300dolly]

As long as you can feed her twice a day thats ok by me.<!--EZCODE EMOTICON START :) --><img src=http://www.ezboard.com/intl/aenglish/im ... /smile.gif ALT=":)"><!--EZCODE EMOTICON END--> <br>
J.

<p></p><i></i>

[2F45T4U]

<!--EZCODE EMOTICON START :p --><img src=http://www.ezboard.com/intl/aenglish/im ... tongue.gif ALT=":p"><!--EZCODE EMOTICON END--> <br>
<br>
If I could weld (and had some cash) it would be turned in to one bad ass kit car! <br>
<br>
This time last year if somebody gave me an engine attatched to gear box with prop shaft, axle and front suspension I would of been the happiest boy around! <br>
<br>
TBH its cos I didnt know what money was then <!--EZCODE EMOTICON START :b --><img src=http://www.ezboard.com/intl/aenglish/im ... tongue.gif ALT=":b"><!--EZCODE EMOTICON END-->

<p></p><i></i>