Door lock help

[alvera]

The drivers door lock sometimes freezes in the lock position so when I close the door it bangs against the lock instead of closing properly. If I then get a screwdriver in the lock and pull the latch it works perfectly.Is this serviceable or does it need replacing ?
If it can be serviced what is required?
If it needs a new one does anyone have one available?

Thanks in advance for any help, Alan

[new to this]

Ive got the same thing on my drivers door ,in my case i think its the grease round the lock mech gone hard and sticky needs cleaning out and regreased or try WD40 round the lock se if it frees up a bit

Dave

[alvera]

Ive got the same thing on my drivers door ,in my case i think its the grease round the lock mech gone hard and sticky needs cleaning out and regreased or try WD40 round the lock se if it frees up a bit

Dave

Hi Dave am I write in saying the door card has to come off to get the lock out to clean it and re-grease?

[new to this]

Ive got the same thing on my drivers door ,in my case i think its the grease round the lock mech gone hard and sticky needs cleaning out and regreased or try WD40 round the lock se if it frees up a bit

Dave

Hi Dave am I write in saying the door card has to come off to get the lock out to clean it and re-grease?

Yes you would need the door card off to clean it propery , but you could try just spraying WD40 around the lock mech at the end of the door and see if it helps

Dave

[Carledo]

If it helps, in 50 years i've NEVER had to replace a latch for failure, they ALWAYS clean up and work right! The hardest part is when the door is stuck shut and can't be opened to get the card off, that takes enginuity and patience!

Steve

[alvera]

Thanks for your help I'll take the door card off and clean it properly. It's reassuring to hear that's all it needs.